![]() ![]() Disclaimer: the description at Amazon is weak, so this could be an incorrect assumption. So, give it 12V on Vcc and run a 0-5V input control voltage. The board separately applies a PWM to the Vcc voltage (5-12V). The description of the linked part but it looks like you can select either a 0-5V or 0-10V analog signal as the control voltage. In most applications it's safe to "blip" the fan to 100% duty cycle for a few seconds to get it spinning and then drop back to the lower, PWM-controlled setting. Non-reddit communities are listed in our getting started guide We welcome community contributions to this wiki! Related Communities ![]() ![]() Hit the report button or message the mods NEED HELP? WE HAVE A WIKI! First layer posts and spaghetti posts are now to only be posted on First layer Fridays and Spaghetti Saturdays respectively.Use the Stickied Purchase Advice Thread.News, information, links, help and fun related to 3D printing, 3D printers, additive manufacturing, etc. ![]()
0 Comments
Leave a Reply. |